Danby Freezer E2 — What It Means & How to Fix It
E2 flags a defrosting (evaporator) sensor failure.
What this code means
Danby's manual lists E2 as defrosting-sensor failure. The defrost system relies on this sensor to know when to turn on the heater; if it fails, ice can build on the evaporator and airflow collapses, eventually warming the cabinet.
Danby's owner's manual for the DUF140A1WDB upright freezer lists this code as "E2: Defrosting sensor failure". Other Danby freezers can use different codes, so match the model number on the rating label inside the cabinet before acting on it.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Failed defrost thermistor | Common | No — technician job |
What you can try yourself
- Unplug 5 minutes; retry.
- If E2 returns, schedule service — defrost sensor is behind interior panels.
When to call a technician
- E2 after reset.
Typical professional repair cost: Defrost-sensor repair quoted by authorized service.
Frequently asked questions
Can I clear E2 with a reset?
Only if it was transient. The manual directs service if it persists — defrost sensors don't recover on their own.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Danby codes
- Danby Freezer E1 E1 is Danby's temperature-sensor fault on upright/freezer models — the control can't trust cabinet temperature.
- Danby Freezer C0 C0 indicates the freezer's control boards aren't communicating — a board-level fault.
- Danby Freezer dr dr means the door isn't fully closed — usually the door seal or latch needs attention.
More: all Danby freezer codes · all Danby codes · search by symptom