Frigidaire Dishwasher i60 — What It Means & How to Fix It
The water isn't heating the way the cycle requires — the element, its relay, or the temperature sensor is at fault, and all of them are mains-voltage parts for a professional.
What this code means
i60 is Frigidaire's heating fault: the control isn't satisfied with how water temperature is rising, implicating the heating element, the circuit driving it, or the sensor reporting back. Cycles may stretch much longer than normal as the unit waits for heat that never arrives, then finish with cold, wet, poorly washed dishes.
One breaker reset is the legitimate user-side test for a glitched reading. Past that, i60 is hardware — no setting, detergent, or supply change reaches the cause.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Failed heating element | Common | No — technician job |
| Temperature sensor fault | Common | No — technician job |
| Heater relay or control fault | Occasional | No — technician job |
| One-off control glitch | Less common | Yes — one breaker reset |
What you can try yourself
- Cut power at the breaker for two minutes, restore, and run a short cycle — the one legitimate self-fix if the reading was a glitch.
- Run the kitchen hot tap before the test so the unit starts with warm supply; it doesn't fix a dead element, but a marginal system completing with warm inlet water is diagnostic information worth noting.
- If i60 returns, stop using the unit and book service — the element and its circuit are mains-voltage parts under the tub.
- Report the pattern to the technician: cycles running absurdly long before erroring is the waiting-for-heat signature and shortens diagnosis.
When to call a technician
- A second i60 after the reset — the user-side road ends there.
- Cycles stretching far past normal length, then finishing cold and wet.
- Any burning smell or breaker trip when the unit runs: off and unplugged until inspected.
Typical professional repair cost: Heating element replacement typically runs $150–$300 with labor; sensor or relay repairs somewhat less.
Frequently asked questions
Why do cycles take twice as long with i60?
Many cycles pause at temperature checkpoints and wait for the water to reach target before proceeding. A dead element turns those checkpoints into long stalls until the control gives up and reports — the marathon cycle is the heater fault experienced in real time.
My dishes smell of detergent since this started — related?
Likely. Detergent dissolves and rinses on the assumption of hot water; cold cycles leave residues and films behind, with odor and cloudiness as side effects. It resolves once heating is restored.
Is i60 ever caused by my home's water heater?
No — the dishwasher heats internally and only treats your supply as a starting point. A cold inlet makes the internal heater work harder but can't by itself trigger the fault. The code is about the machine's own heating system.
Related Frigidaire codes
- Frigidaire Dishwasher i10 Water isn't reaching the tub fast enough — the under-sink valve, a kinked line, or a stuck float explain most i10 errors before any part needs replacing.
- Frigidaire Dishwasher i20 The unit didn't drain properly — Frigidaire's filters and glass trap clog like any brand's, and the drain hose and disposal connection make up the rest of the usual story.
- Frigidaire Dishwasher i30 Water collected in the pan beneath the tub and the anti-leak response took over — the cause ranges from a one-off overflow or suds episode to a genuine seal failure.
More: all Frigidaire dishwasher codes · all Frigidaire codes · search by symptom