Frigidaire Washer E47 — What It Means & How to Fix It
Your Frigidaire front-load washer saw the door-lock circuit open during the spin step, so it stopped — usually a door-lock assembly that is failing under the vibration of high-speed spin rather than anything you did.
What this code means
E47 is the spin-specific door-lock fault: partway through a cycle the control stops getting the 'locked' confirmation, specifically while spinning. The high-speed vibration can expose a worn lock or a marginal wiring connection that holds fine at rest. It is closely related to E41, but the timing — during spin, not at the start — points more squarely at the lock assembly.
E47 sits in the same door-lock family as E41 on Frigidaire front-loaders and blinks on the status lights on non-display models. If your machine fails to lock at the very start instead of dropping out in spin, the E41 page fits better.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Worn door-lock / switch assembly that drops out under vibration | Common | No — technician job |
| Loose or chafed wiring to the door lock | Occasional | No — technician job |
| Door not fully latched, working loose during spin | Occasional | Yes — no tools |
| Control board fault | Less common | No — technician job |
What you can try yourself
- Make sure the door is shut firmly and the latch area is clean — start with the simple, free checks.
- Unplug the washer for five minutes, then restore power to clear the fault state.
- Run a spin-only cycle and see whether E47 returns specifically when the drum speeds up.
- If it drops out in spin each time, the door-lock assembly is the likely culprit and needs a technician — the lock and its wiring sit on circuits an owner shouldn't open up.
When to call a technician
- E47 appears every time the machine reaches spin.
- The latch looks fine but the code keeps stopping the cycle mid-way.
- The door lock buzzes or clicks repeatedly during spin.
Typical professional repair cost: Replacing the door-lock assembly generally costs $130–$250 with labor.
Frequently asked questions
What's the difference between E41 and E47?
Both are door-lock faults, but E41 means the door won't lock at the start of a cycle, while E47 means the lock signal drops out during spin. E47's timing points at a lock that fails under vibration.
Why does my Frigidaire stop only during spin with E47?
High-speed spin shakes the whole machine, and a worn lock or a marginal wire connection that is fine when still can lose contact then. The control reads that as the door unlocking and stops for safety.
Is E47 safe to ignore?
No — the machine is stopping because it can't confirm the door is secured at the most forceful part of the cycle. Running it that way defeats a safety interlock, so get the lock checked.
Related Frigidaire codes
- Frigidaire Washer E11 Your Frigidaire front-load washer opened its fill valve but the water level didn't rise fast enough and timed out — almost always a restricted supply at the taps, hoses, or inlet screens rather than a dead valve.
- Frigidaire Washer E13 Your Frigidaire front-load washer has detected a leak — either water escaping the outer tub or, just as often, an air leak in the thin hose that lets the pressure sensor read the water level.
- Frigidaire Washer E20 Your Frigidaire front-load washer can't pump the water out, almost always because something is blocking the drain path — the pump filter, the drain hose, or the standpipe — rather than a failed pump.
- Frigidaire Washer E21 Your Frigidaire front-load washer is draining, but too slowly to satisfy the control within its time limit — usually a partial blockage in the pump filter or hose, or a drain pump that is losing strength.
More: all Frigidaire washer codes · all Frigidaire codes · search by symptom