Wolf Range Probe Shorted — What It Means & How to Fix It
Also shown as PROBE SHORTED on some models.
'Probe Shorted' on a Wolf L Series or E Series wall oven means the temperature probe has failed — and unlike most Wolf codes, the documented fix is a part you can replace yourself.
What this code means
Wolf's built-in oven answer is straightforward about this one: if the display shows 'Probe Shorted,' replace the temperature probe. It's the temperature probe (the oven sensor) failing, not an electrical mystery. Wolf documents ordering the part through a factory-certified parts distributor, replacing it, then resetting power at the circuit breaker to clear the code. If a fresh probe doesn't clear it, the fault trails into the wiring or control and needs certified service.
Documented for both L Series and E Series wall ovens. Order a probe matched to your exact model — Wolf's probe style varies by family.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Temperature probe failure | Common | Yes — replace the probe |
| Probe connector or lead damaged | Occasional | No — technician job |
| Control board misreading a good probe | Less common | No — technician job |
What you can try yourself
- Confirm the display really says 'Probe Shorted' and note whether a probe is actually plugged into the jack.
- Unplug the oven at the breaker, then replace the temperature probe with a genuine part matched to your exact model.
- Reset the power at the circuit breaker after the swap — Wolf notes this is often needed to clear the error code.
- Run a cycle and confirm the code stays gone.
- If 'Probe Shorted' returns with a fresh, correctly seated probe, stop and book factory-certified service.
When to call a technician
- The code returns after replacing the probe — the fault has moved to the harness or the control.
- Any burning smell, arcing, or discoloration around the probe or its connector — stop and call.
Typical professional repair cost: A Wolf temperature probe is typically $60–$130 for the part; with a technician doing the swap, plan on $150–$350 including the visit.
Frequently asked questions
Is replacing the probe really something I can do safely?
Wolf documents exactly this as the fix — replace the probe, then reset the breaker. Work with the oven unplugged, order a genuine part for your model, and follow your manual's access steps. If you're not comfortable opening the oven, any certified shop can do it.
What if 'Probe Shorted' shows even with no probe plugged in?
Then the problem is in the probe circuit itself — the connector or wiring — and that's the point where Wolf's own answer pivots to service. A fresh probe plus a breaker reset is the full owner step list.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Wolf codes
- Wolf Range F1 F1 on a Wolf L Series wall oven is a door-lock sensing fault: the control didn't see the lock or unlock switches within 60 seconds while driving the door-lock motor.
- Wolf Range COMM ERR COMM ERR on a Wolf L Series built-in oven means the control panel lost communication with the oven controller — Wolf's own cause is exactly 'communication lost with the oven controller.'
- Wolf Range 03 err 03 on a Wolf Legacy dual fuel range declares an open circuit on the RTD oven temperature sensor — often with the cooling fans running non-stop.
More: all Wolf range codes · all Wolf codes · search by symptom