Fisher & Paykel Washer E7:00 — What It Means & How to Fix It
E7:00 on a Fisher & Paykel front-loader is a motor error — a licensed technician's readout that usually ends in a motor or controller service visit.
What this code means
E7:00 is the motor-error fault on Fisher & Paykel front-loading washers: the machine detected the motor wasn't reading or behaving as expected. Fisher & Paykel's own guidance for the E7:xx series is to reset the washer once — if the code returns, you'll want a trained service technician, because it points at the drive motor, its controller, or the wiring between them. There's no safe owner-side repair here.
Listed in Fisher & Paykel's support article 'F&P Washing Machine – Front Loader Fault Codes', where E7:00 is described as a motor error requiring a service technician; it's a fault-code readout on display-equipped front-loaders.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Motor controller issue | Common | No — technician job |
| Drive motor fault | Common | No — technician job |
| Loose or damaged motor wiring connector | Occasional | No — technician inspection |
| One-off electronic glitch | Occasional | Yes — power reset |
What you can try yourself
- Press the dial to turn the washer off, wait a few seconds, and press it again to turn it back on — the reset Fisher & Paykel documents for E-codes.
- Run a short cycle with an empty machine to see whether E7:00 clears.
- If the code returns, note the exact code and stop — motor and controller work is for a Fisher & Paykel trained technician.
- Find the model number on the sticker (above the door opening) so the technician comes prepared with the right parts.
When to call a technician
- E7:00 returns even on an empty cycle.
- The washer stops mid-cycle with the code and won't advance from the motor check.
Typical professional repair cost: A motor or controller service visit typically runs $250–$500 depending on which part needs replacing.
Frequently asked questions
What does E7:00 mean on a Fisher & Paykel washer?
It's the motor-error code on display-equipped front-loaders — the machine isn't getting a normal reading from the drive motor. Fisher & Paykel's advice after one reset is to call a service technician.
Can a power reset fix E7:00?
Sometimes — a one-off glitch can clear with the documented off/on reset. If the code returns on the next empty cycle, treat it as a genuine motor-side fault and book service.
Is it safe to keep washing with E7:00 showing?
No — the code means the machine has stopped the cycle because it can't trust the motor. Keep it off and let the technician diagnose rather than forcing cycles.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Fisher & Paykel codes
- Fisher & Paykel Dishwasher F1 F1 on a DishDrawer is the flood-switch code — the machine has detected water where it shouldn't be, and it will keep beeping until it's dealt with.
- Fisher & Paykel Dishwasher F3 F3 on a DishDrawer flags a temperature-sensor fault — and a very hot incoming water supply is the one cause you can check and fix yourself.
- Fisher & Paykel Dishwasher F4 F4 on a DishDrawer points to the heating side — the water isn't reaching temperature. Beyond one reset, the element or sensor needs a technician.
- Fisher & Paykel Dishwasher U1 U1 is the DishDrawer fill fault — not enough water arrived in the allowed time. Most times it's the tap, a kinked hose, or a spray arm you can fix yourself.
More: all Fisher & Paykel washer codes · all Fisher & Paykel codes · search by symptom