GE Range F7 — What It Means & How to Fix It
Also shown as F-7 on some models.
F7 on a GE range is a keypad fault — GE's chart reads that there is a problem with the keypanel, often meaning replacement. Clean it, reset, then diagnose.
What this code means
F7 is GE's keypanel fault: GE's official fault-code chart reads 'this code usually means that there is a problem with the keypanel. Many times, it means the keypanel needs to be replaced.' F1, F6, and F7 all live in this same keypad family depending on model generation. GE's own starting point is a short reset at the breaker, which clears many codes, and keeping the range off at the breaker until serviced if it doesn't.
GE's official range and wall oven fault-code page lists F7 under the same keypanel problem definition as F1 and F6. The model number is on the frame behind the storage drawer or the oven door frame.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Stuck or sticky key on the touch panel | Very common | Yes — clean the panel |
| Moisture or grease bridging the keypad | Common | Yes — dry the panel |
| Keypad board failed | Occasional | No — technician job |
| Control board misreading the keypad | Less common | No — technician job |
What you can try yourself
- Wipe the keypad dry and clean, pressing every key once to work them free.
- Reset the range at the breaker for a minute or two, restore power, and watch whether F7 returns on boot.
- Press each key individually and confirm the display response — a key that reads itself identifies itself.
- If F7 persists after a clean, dry panel and a reset, the keypad or the control board needs a technician's diagnosis.
When to call a technician
- F7 returns after the panel is clean and dry and the breaker was cycled.
- The range beeps or enters keys by itself.
- The whole control goes unresponsive alongside the code.
Typical professional repair cost: No cost if cleaning and a reset cure it; keypad or control-board replacement typically runs $150–$400 including labor.
Frequently asked questions
How do F1, F6, and F7 differ?
Only in the digit GE assigned that model generation — the chart's definition is identical for all three: a problem with the keypanel, many times meaning replacement. Use whichever code your display shows.
Should I replace the keypad right away?
No — GE's own chart says the code 'usually means' a keypad problem, and the reset note says many codes clear at the breaker. Clean, dry, reset, and only then talk parts.
Can a child's toy on the panel trigger F7?
Anything resting on a touch key reads like a constant press — the same way a stuck key does. Removing it and cleaning the panel is the cheapest possible fix.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related GE codes
- GE Range F2 F2 (F20 on some models) on a GE range is the over-temperature alarm: the oven exceeded its heat limit — usually a stuck bake or broil element, sometimes a sensor.
- GE Range F1 F1 on a GE range points at the keypad (keypanel): a stuck key, moisture under the touch panel, or the keypad's own circuit — occasionally the control board behind it.
- GE Range F3 F3 on a GE range is the oven temperature sensor fault — the probe reads open circuit (F4 is the shorted variant). Reset first, then a sensor or wiring diagnosis.
- GE Range F5 F5 on a GE range is the control-board fault: the main electronic control isn't behaving — shown as F8 or FF on some models. Reset once; recurring F5 means a board.
More: all GE range codes · all GE codes · search by symptom