Hisense Washer F03 — What It Means & How to Fix It
Also shown as F3 on some models.
Your Hisense washer can't drain — F03 is the drainage fault, usually a clogged pump filter, a kinked drain hose, or a blocked standpipe.
What this code means
F03 on a Hisense washer means the water didn't pump away in time. The drum is left with water in it and the cycle stops before spin. The pump filter and drain hose are the first checks; the pump itself is the last suspect.
Most Hisense front-loaders have a pump filter behind a small flap at the lower front — expect some water when you open it. Top-load models may route differently, so check your manual for the filter location.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Clogged pump filter or trapped object | Very common | Yes — towel, 20 min |
| Kinked or crushed drain hose | Common | Yes — no tools |
| Drain hose too high or too deep in the standpipe | Occasional | Yes — reposition |
| Blocked standpipe or house drain | Occasional | Partly — check the drain |
| Failed drain pump | Less common | No — technician job |
What you can try yourself
- Switch off and check the drain hose for kinks or crushing.
- Open the lower-front flap, lay towels down, and unthread the pump filter to drain it and clear any trapped debris.
- Make sure the hose sits at the right height and isn't jammed deep into the standpipe.
- Pour water down the standpipe to confirm the house drain is clear.
- Clear F03 (switch off at the wall for a minute) and run a drain/spin to retest.
When to call a technician
- The filter and hose are clear but water won't drain.
- The pump hums without moving water, or is silent.
- The standpipe backs up when the washer drains.
Typical professional repair cost: Drain pump replacement on a Hisense washer typically runs $130—$260 including labor.
Frequently asked questions
Where is the drain filter on a Hisense washer?
On most front-loaders it's behind a small flap at the bottom-front of the machine. Lay towels down before opening it — water will come out. Cleaning it clears most F03 faults.
Why is my Hisense washer full of water with F03?
The pump couldn't clear the water in time, so it's left in the drum. Clean the pump filter and check the drain hose, then run a drain/spin to empty it.
Could a coin cause F03?
Yes — coins and small items that slip past the drum lodge in the filter or pump and block the drain. The pump filter catches most of them, which is why cleaning it usually fixes F03.
Related Hisense codes
- Hisense Washer F01 Your Hisense washer isn't filling — F01 is the water-inlet fault, usually a closed tap, a kinked hose, or a clogged inlet filter rather than the valve.
- Hisense Washer F02 Your Hisense washer sensed too much water — F02 is the overflow fault, so turn off the tap; the usual causes are a stuck inlet valve or a pressure-sensor problem.
- Hisense Washer dE Your Hisense washer can't confirm the door is locked — dE is the door-lock fault, so the cycle won't start until it's satisfied the door is shut.
- Hisense Washer FA Your Hisense washer detected a leak — FA is the anti-flood trip, so turn off the supply; finding and fixing the leak is a technician job.
More: all Hisense washer codes · all Hisense codes · search by symptom