Kenmore Refrigerator Er FF — What It Means & How to Fix It
Also shown as E FF, F FF on some models.
Er FF is the LG-built Kenmore 795/796 family's way of saying the freezer fan has stalled, is blocked by ice, or its motor is failing.
What this code means
On LG-built Kenmore 795/796 refrigerators (model prefix 795 or 796), Er FF reports a fault in the freezer fan circuit. The control board can't confirm the freezer fan is spinning, so temperatures in the freezer can drift until the fan is cleared or replaced.
Verify against the model number printed inside the fresh-food section: this is the LG-built Kenmore 795/796 platform, and Er FF is that platform's freezer-fan fault per LG/Kenmore service-manual code references.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Frost or ice build-up jamming the freezer fan blade | Common | Yes - inspect the freezer and thaw any ice hugging the fan area. |
| Faulty freezer fan motor | Common | No - fan motor replacement usually means opening the freezer's rear panel. |
| Loose or damaged fan wiring harness | Occasional | Cautious - you can inspect the connector, but leave rewiring to a tech. |
What you can try yourself
- Unplug the refrigerator and fully open the freezer door to inspect for ice, frost, or packaging blocking the fan blade.
- Gently clear any ice build-up, pull out anything wedged near the fan, and let the freezer thaw completely if the fan was frozen over.
- Plug the unit back in and listen a few minutes later: if the freezer fan still won't spin, the motor or its harness needs professional attention.
- Keep the freezer door closed while the unit recovers, and check back over a few hours to see whether Er FF clears or returns.
When to call a technician
- Stop if the fan sits behind a sealed rear panel or clipped wiring harness - leave motor swaps to a licensed tech.
- Stop and call a pro if the freezer is already way too warm and food has thawed - handle food safety first.
Typical professional repair cost: $150-$350
Frequently asked questions
Can I just clear Er FF and ignore it?
You can reset the display by unplugging for about five minutes, but if the freezer fan is truly dead the code comes back and temperatures drift.
Is Er FF the same as the condenser fan error?
No - Er FF is the freezer fan. The LG-built 795 family reports the condenser (machine-room) fan separately as Er CF.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Kenmore codes
- Kenmore Refrigerator Er rF Er rF says the fan in the fresh-food (refrigerator) section of an LG-built Kenmore isn't spinning as it should.
- Kenmore Refrigerator Er dS Er dS flags a problem in the defrost system's temperature sensing on LG-built Kenmore 795/796 refrigerators.
- Kenmore Refrigerator Er dH Er dH is the LG-built Kenmore 795/796 defrost-heater fault - the heating circuit that melts frost off the evaporator isn't working.
- Kenmore Refrigerator Er CF Er CF is the LG-built Kenmore 795/796 condenser fan fault - the fan that cools the compressor and coils has stopped.
More: all Kenmore refrigerator codes · all Kenmore codes · search by symptom