Miele Washer Error Codes — Complete List

Miele washers and washer-dryers share a tight F-code family — the NTC temperature-sensor pair (F1 = short, F2 = open), the intake/drain pair (F10/F11), heating (F20), the spin check (F56), a waterproof-system warning (F138) and the water path control unit (F63). The pattern to know: intake, drain and balance faults are often owner-checkable; anything electronic is a booked-repair code, and Miele USA's own guidance for F63 is simply "book a repair online."

• F1 (F 1) F1 on a Miele washer is a short circuit in the heating/water-temperature sensor circuit — a reset is worth one try, then it's technician work.
• F2 (F 2) F2 is the open-circuit twin of F1 — the temperature sensor reads disconnected, so the heater stands down until a technician confirms the sensor or wiring.
• F10 F10 means the washer isn't getting enough water — closed stopcock, blocked inlet filter or a faulty inlet valve — and the first fixes are all done at the plumbing, not in the machine.
• F11 F11 on a Miele washer is a drainage fault — usually a blocked debris filter, a kinked hose or a failing drain pump, and the filter clean is a safe first move.
• F20 F20 says the washer's heater isn't getting the water to temperature — a reset is safe to try, but element and sensor testing is multimeter work.
• F56 F56 means the final spin couldn't reach even 400 rpm — and the most common cause is a heavy or lopsided load, which is a simple fix.
• F63 F63 is Miele's water path control unit fault — an internal module failure that Miele USA tells owners to book a repair for rather than attempt at home.
• F138 F138 means the safety tray under the tub sensed water and the machine stopped — unplug, drain collected water, and if it recurs, that's a leak to trace.

Don't see your code?

Match your exact Miele model and display type before acting; newer G 7xxx machines may show lights instead of numbers.

Also from Miele: Miele dishwasher error codes Miele dryer error codes Miele refrigerator error codes