Samsung Dryer bE — What It Means & How to Fix It
Also shown as bE2, bC2, 6E, 6E2, 6C2 on some models.
bE means the Samsung dryer thinks one of its panel buttons is stuck down or being held — often just a sticky or debris-blocked button that frees up once you power off and work each one back and forth.
What this code means
The control scans the buttons continuously, and bE (with variants bE2, bC2, 6E, 6E2 and 6C2) appears when one registers as pressed for too long. That can be as simple as a button gummed up by residue or a panel that got bumped, or as involved as a failed membrane behind the controls.
bE and the 6-series variants all describe the same stuck-button condition. If exercising the buttons doesn't free it, or one is visibly damaged, the panel or control board is failing and the code won't clear on its own.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| A button physically stuck, sticky, or blocked by debris | Common | Yes — no tools |
| Residue or a spill gumming up the panel | Occasional | Yes — no tools |
| Failed button membrane or control panel | Occasional | No — technician job |
| Moisture that got behind the control panel | Less common | No — technician job |
What you can try yourself
- Power the dryer off — unplug it or switch off its breaker — to stop the code and reset the panel scan.
- Press and release every button one at a time, working across and around each so a stuck one pops back up, and note any that feel mushy or don't click.
- Wipe the panel with a barely damp cloth to lift residue around the button edges, then let it dry fully.
- Restore power and test. If the dryer runs normally, a sticky button was the cause.
- If bE returns or a button is clearly stuck or dead, the control panel needs professional replacement.
When to call a technician
- The code comes straight back after powering off and exercising the buttons.
- A button is visibly cracked, sunken, or completely unresponsive.
- The panel got wet and the code appeared shortly afterward.
Typical professional repair cost: A Samsung dryer control panel or button board replacement generally costs $150–$300 with labor, depending on the model.
Frequently asked questions
How do I fix a bE code on my Samsung dryer?
Turn the dryer off at the plug or breaker, then press and release each control-panel button in turn to free any that are stuck. Wipe away residue around the buttons and let it dry, then restore power and test. If a sticky button was the issue, the dryer will run normally.
Why does my Samsung dryer keep showing 6E?
6E is one of the stuck-button variants alongside bE. If it keeps returning after you've exercised and cleaned the buttons, one of them is likely failing or there's moisture behind the panel. At that point the control panel needs replacing by a technician.
Related Samsung codes
- Samsung Dryer dC Your Samsung dryer shows dC when it can't confirm the door is shut and latched, so the drum won't turn — usually a door caught on laundry, a misaligned strike, or a tired latch switch rather than anything deep inside the machine.
- Samsung Dryer HC HC is Samsung's overheating warning: the dryer sensed the drum getting hotter than it should and cut the heat to stay safe — nine times out of ten because a clogged lint filter or blocked exhaust vent is trapping heat inside.
- Samsung Dryer tS tS on a Samsung dryer flags a problem with the temperature reading itself — the sensor is reporting a value the control doesn't trust — and the most common trigger is a clogged lint filter or vent throwing readings off rather than a dead part.
- Samsung Dryer 9C1 9C1 tells you the Samsung dryer is seeing abnormal electrical supply — too high, too low, or unstable — most often from an extension cord, a shared or miswired outlet, or a power cord that isn't fully seated.
More: all Samsung dryer codes · all Samsung codes · search by symptom