Electrolux Washer E35 — What It Means & How to Fix It
E35 is the washer's 'too much water' alarm — the pressure sensor says the tub is overfilled, and the washer drops into a safety drain.
What this code means
E35 means the pressure sensor is reporting the tub as overfilled — the washer believes the water level is too high and runs a safety drain. Electrolux notes reversed or mis-wired supply lines after a recent install as a known cause.
Applies to Electrolux front-load washers (EFL/ELFW series); Electrolux flags E35 as a known installation issue on recently moved or installed machines, so confirm wiring before chasing parts.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Recent installation or move with mis-wired supply lines (known installer issue) | Common | Yes — have the installer re-verify |
| Water inlet valve stuck open, letting water run continuously | Common | No — technician job |
| Pressure switch or air trap giving a false reading | Occasional | No — technician job |
| Control board misreading the sensor | Less common | No — technician job |
What you can try yourself
- Press Cancel to clear the E35 display; if it disappears, try resuming the cycle with Start.
- Do a hard reset: unplug the washer, wait a couple of seconds after reconnecting, and restart the cycle.
- If the washer was recently installed or moved, have the installer verify the hot and cold hookups — Electrolux calls this a known installation issue.
- If water keeps running into the tub, unplug the washer and call a technician — a stuck-open inlet valve needs replacing.
Seeing the symptom rather than the code? Washer won't drain: checks that apply across brands.
When to call a technician
- Constant water flow means a stuck-open valve — unplug the washer before it overflows.
- Two resets with no improvement are your cue to stop; repeated attempts can mask a hardware fault.
- If you see water on the floor, close the supply valves as well as unplugging.
Typical professional repair cost: $0 for a simple reset; $100–$300 for a professional inlet-valve or pressure-switch repair
Frequently asked questions
Is E35 a serious problem?
Not always — a reset clears some one-off overfill scares. Persistent E35 points to a stuck valve or a faulty sensor.
Why does installation matter?
Electrolux lists E35 as a known installation issue — reversed supply lines after a move or install can make the washer fill and read wrong.
Can I keep using the washer when E35 shows?
No — the washer is in a safety drain for a reason. Clear it, watch one full cycle, and if it returns, stop and get it checked.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Electrolux codes
- Electrolux Washer E11 E11 appears when the wash phase tries to fill but can't reach the right water level in time — water is arriving, just too slowly, or not at all.
- Electrolux Washer E13 E13 is the washer's leak alarm — it senses water where it shouldn't be, usually in or under the tub area, and stops the cycle to protect the electronics.
- Electrolux Washer E21 E21 appears when the pump-out phase runs longer than the washer allows; water is still leaving the tub, just not fast enough.
- Electrolux Washer E31 E31 points to the electronic pressure switch — the part that tells the washer how full the tub is — and the control board is rejecting its signal.
More: all Electrolux washer codes · all Electrolux codes · search by symptom