Haier Washer Err2 — What It Means & How to Fix It
Also shown as Err 2 on some models.
Your Haier washer couldn't pump out in time — Err2 is the drain fault, raised when the tank doesn't empty within the program's drain window, usually a blocked filter or hose.
What this code means
Err2 on a Haier washing machine is the drain fault: the water didn't clear within the time the program allows (around four minutes). The drain pump filter and hose are the first checks; the pump itself is the last suspect.
Err2 is a full-size Haier code. Most front-loaders have a pump filter behind a small flap at the lower front — expect water when you open it. Portable Haier models use letter codes instead, so confirm your display style.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Clogged drain pump filter or trapped object | Very common | Yes — towel, 20 min |
| Kinked or crushed drain hose | Common | Yes — no tools |
| Drain hose too high or too deep in the standpipe | Occasional | Yes — reposition |
| Blocked standpipe or house drain | Occasional | Partly — check the drain |
| Failed drain pump | Less common | No — technician job |
What you can try yourself
- Switch off and check the drain hose for kinks or crushing.
- Open the lower-front flap, lay towels down, and unthread the pump filter to drain it and clear trapped debris.
- Make sure the hose sits at the right height and isn't jammed deep into the standpipe.
- Pour water down the standpipe to confirm the house drain is clear.
- Clear Err2 (switch off at the wall for a minute) and run a drain/spin to retest.
When to call a technician
- The filter and hose are clear but water won't drain.
- The pump hums without moving water, or is silent.
- The standpipe backs up when the washer drains.
Typical professional repair cost: Drain pump replacement on a Haier washer typically runs $130—$260 including labor.
Frequently asked questions
Where is the drain filter on a Haier washer?
On most full-size front-loaders it's behind a small flap at the bottom-front. Lay towels down before opening it — water will come out. Cleaning it clears most Err2 faults.
Why is my Haier washer full of water with Err2?
The pump couldn't clear the water in the program's drain time, so it's left in the drum. Clean the pump filter and check the drain hose, then run a drain/spin.
Could a coin cause Err2?
Yes — coins and small items that slip past the drum lodge in the filter or pump and block the drain. The pump filter catches most of them, which is why cleaning it usually fixes Err2.
Related Haier codes
- Haier Washer dO Your Haier portable washer thinks the lid is open — dO (shown as E0 or E2 on some units) is the lid-switch code, so it won't spin until the lid reads closed.
- Haier Washer dd Your Haier washer flagged dd during the spin — it's the out-of-balance code, cleared by spreading the load evenly and levelling the machine.
- Haier Washer Err5 Your full-size Haier washer didn't fill to level in time — Err5 is the fill fault, usually a closed tap, a kinked hose, or a clogged inlet filter.
- Haier Washer Err7 Your Haier washer detected a motor-speed fault — Err7 is a motor/control error, and beyond a single power reset it's a technician repair.
More: all Haier washer codes · all Haier codes · search by symptom