Maytag Washer Error Codes — Complete List

Maytag washers built in the last decade share Whirlpool's paired F-and-E fault system — F5 E2, F8 E1, F9 E1 — where the F number names the subsystem and the E number pinpoints the fault, alongside plain readouts like Sud for excess foam and oL for an overloaded basket. Every code below is verified against Maytag's own product-help documentation, each with ranked causes and the steps that are safe to try yourself.

• F8 E1 (Lo FL, LF, F8E1) Your Maytag washer started filling but isn't sensing enough water arriving — nearly always a supply-side issue with the taps, hoses, or inlet screens rather than a fault inside the machine.
• F9 E1 (F9E1) Your Maytag washer is taking too long to pump out — the machine flags F9 E1 when the water hasn't cleared within about eight minutes, usually because something is blocking the drain path.
• F5 E2 (F5E2) Your Maytag washer tried to lock the door or lid and couldn't — most often something is physically blocking the latch, or the lock assembly itself has worn out.
• F5 E3 (F5E3) Your Maytag washer finished but the door or lid won't release — usually because water is still in the tub holding the lock, with a worn lock assembly behind the stubborn cases.
• F7 E1 (F7E1) Your Maytag washer's control isn't getting the motor speed it expects — F7 E1 is a basket/motor speed-sensing fault, often traced to drum drag, the shifter actuator, or the motor's speed sensor.
• F0 E2 (Sud, Sd, F0E2) Your Maytag washer has detected too many suds and is running an automatic suds-reduction routine — almost always caused by too much detergent or a non-HE detergent rather than a hardware fault.
• F8 E2 (F8E2) Your Maytag washer can't move its detergent dispenser into position — F8 E2 flags a dispenser-system fault, usually a clogged drawer or a stuck dispenser actuator.
• F2 E1 (F2E1) Your Maytag washer's control thinks a button is stuck down — F2 E1 is a stuck-key fault, often from a held or sticky button, moisture on the panel, or a failing touch interface.
• F1 E1 (F1E1) Your Maytag washer has logged a main control board fault — F1 E1 points to an internal error in the central control unit (ACU), and the only safe owner step is a power reset before calling a technician.
• F3 E1 (F3E1) Your Maytag washer can't read its water level — F3 E1 indicates a pressure-sensor or water-level system fault, often a blocked pressure hose rather than the sensor itself.
• oL (OL) Your Maytag washer is telling you the load is too big — the oL code means the basket is overloaded, and the fix is simply to take some laundry out and redistribute the rest.
• uL (UL) Your Maytag washer has found an uneven load during spin — the uL code means the laundry is bunched to one side, and redistributing it lets the machine balance and spin up safely.

Don't see your code?

Maytag shares this code platform with Whirlpool and Amana, but the exact list varies by model and generation — a top-loader's lid lock and a front-loader's door latch report the same F5 family a little differently. If your display shows a code that isn't here, the tech sheet for your model number (inside the door or under the lid) is the authority.

Also from Maytag: Maytag dishwasher error codes