Whirlpool Range Hood F — What It Means & How to Fix It
F on a Whirlpool range hood means the grease filter is due for washing after 30 hours of fan operation — wash and dry the metal filter, then press and hold FAN for 3 seconds to reset.
What this code means
Whirlpool says the display shows F when the fan is active after 30 hours of fan operation, meaning the grease filters should be washed. Clean the metal filter in the dishwasher or a hot detergent solution, let it dry thoroughly, refit it, and hold FAN for 3 seconds to reset. An F shown briefly for 3 seconds after holding + and − is confirmation that the charcoal alarm was disabled.
Whirlpool vent hoods with a display.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| 30 hours of fan use reached | Very common | Yes — wash filter |
What you can try yourself
- Remove the metal grease filter.
- Wash it in the dishwasher or hot detergent solution.
- Let it dry thoroughly and refit.
- Press and hold FAN for 3 seconds to clear F.
When to call a technician
- F will not reset.
- Filter bent or damaged.
- Fan weak with a clean filter.
Typical professional repair cost: Free.
Frequently asked questions
What does F mean on a Whirlpool range hood?
The grease filter should be washed; it shows after 30 hours of fan operation.
How do I clean the grease filter?
In the dishwasher or a hot detergent solution, then dry thoroughly.
How do I reset F?
Press and hold FAN for 3 seconds.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Range Hood C C on a Whirlpool range hood means the charcoal filter is due for washing after 120 hours of fan operation — clean and reactivate it, then press and hold FAN for 3 seconds to reset.
- Whirlpool Washer F9 E1 The washer took too long to drain — check the drain hose setup and the pump filter; the 'hose pushed too far down the standpipe' mistake causes a surprising share of these.
- Whirlpool Washer F5 E2 The washer tried to lock its door and couldn't — usually an obstruction or grime in the latch, sometimes a worn lock assembly that needs replacing.
- Whirlpool Washer SD Too much foam — the washer paused its cycle to break down excess suds, which almost always traces back to detergent amount or type rather than a fault.
More: all Whirlpool range hood codes · all Whirlpool codes · search by symptom