Whirlpool Washer Dryer Combo F0E3 — What It Means & How to Fix It
Also shown as F0 E3 on some models.
F0E3 means temperatures inside the machine got too hot during the dry cycle — check you are using the right cycle for the fabric, then unplug for 5 minutes to reset.
What this code means
Whirlpool says F0E3 indicates the temperatures in the washer/dryer are too hot during the dry cycle. Verify you are using the right cycle for the fabrics, and reset by unplugging for at least 5 minutes.
Whirlpool all-in-one (ventless) washer dryers. On Whirlpool top-load washers F0E3 means overload instead.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Cycle too hot for the load | Common | Yes — change cycle |
| Overfilled drum restricting airflow | Common | Yes — reduce load |
| Sensor or heater fault | Occasional | No — technician job |
What you can try yourself
- Open the door once unlocked and let the load cool.
- Pick a cycle suited to the fabric.
- Unplug for at least 5 minutes, then plug back in.
- Call for service if it repeats.
When to call a technician
- Repeat code.
- Scorched smell or clothes.
- Cabinet very hot.
Typical professional repair cost: Free if cycle-related; otherwise $150–$350.
Frequently asked questions
What does F0E3 mean on an all-in-one?
Temperatures are too hot during the dry cycle.
How do I reset?
Unplug for at least 5 minutes.
Same as washer F0E3?
No — on top-load washers it is an overload code.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Washer Dryer Combo F0E1 F0E1 means you started a Clean Washer cycle and the machine detects items still inside — remove the load and restart the cycle.
- Whirlpool Washer Dryer Combo F0E2 F0E2 means excessive suds were detected and the machine is running a suds reduction routine — let it finish, then switch to measured HE detergent and run a Clean Washer cycle.
- Whirlpool Washer Dryer Combo F0E4 F0E4 means the wash water is too hot, usually because the machine is connected to the hot supply — it must be connected to cold water only.
- Whirlpool Washer Dryer Combo F0E5 F0E5 means an off-balance load was detected — the load is too large or uneven, so reduce or rearrange it and avoid washing single items.
More: all Whirlpool washer dryer combo codes · all Whirlpool codes · search by symptom