Whirlpool Washer E2 — What It Means & How to Fix It
E2 on a stacked laundry center is a draining alarm — the washer is still draining after 8 minutes — so clear the drain hose and make sure it is no more than about 39 inches (100 cm) from the floor.
What this code means
Whirlpool says E2 indicates the washer is still draining after 8 minutes. Check the drain hose is not more than 100 cm from the floor and remove any clogs.
Whirlpool stacked laundry centers (some models).
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Clogged drain hose | Common | Yes — clear |
| Drain hose too high | Common | Yes — lower |
| Pump fault | Occasional | No — technician job |
What you can try yourself
- Check the drain hose for clogs and kinks.
- Confirm the drain height is under 100 cm.
- Restart a drain or spin.
- Service if it persists.
Seeing the symptom rather than the code? Washer won't drain: checks that apply across brands.
When to call a technician
- Clear hose, still slow.
- Pump silent.
- Water left in the tub.
Typical professional repair cost: Free; pump $150–$250.
Frequently asked questions
What does E2 mean?
Still draining after 8 minutes.
Max drain height?
100 cm from the floor.
Fix?
Clear the hose.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Washer F9 E1 The washer took too long to drain — check the drain hose setup and the pump filter; the 'hose pushed too far down the standpipe' mistake causes a surprising share of these.
- Whirlpool Washer F5 E2 The washer tried to lock its door and couldn't — usually an obstruction or grime in the latch, sometimes a worn lock assembly that needs replacing.
- Whirlpool Washer SD Too much foam — the washer paused its cycle to break down excess suds, which almost always traces back to detergent amount or type rather than a fault.
- Whirlpool Washer F8 E1 Your Whirlpool washer isn't detecting water coming in — usually a supply problem (taps, hoses, screens) rather than anything wrong inside the machine.
More: all Whirlpool washer codes · all Whirlpool codes · search by symptom