Whirlpool Washer F0 E8 — What It Means & How to Fix It
Also shown as F0E8 on some models.
F0E8 means the washer detected too much water left in the tub — run a Drain and Spin cycle to clear it and call for service if the code keeps returning.
What this code means
Whirlpool titles F0E8 Water remains in tub: too much residual water was detected in the washer. The remedy it gives is to run a Drain and Spin cycle to remove the water, with a service call if the problem persists.
Published in Whirlpool's top-load washer help. A separate code, F9E1, covers drains that take too long.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Cycle interrupted before the final drain | Common | Yes — no tools |
| Kinked or clogged drain hose leaving water behind | Common | Yes — no tools |
| Drain pump not clearing the tub | Occasional | No — technician job |
What you can try yourself
- Select the Drain and Spin cycle and let it finish.
- While it runs, check behind the washer that the drain hose is not kinked or flattened.
- Lift the lid when the cycle ends and confirm the tub is empty.
- Start your wash again. If F0E8 returns, stop and call for service.
Seeing the symptom rather than the code? Washer won't drain: checks that apply across brands.
When to call a technician
- Water is still in the tub after a Drain and Spin cycle.
- F0E8 comes back on the next load.
- The pump is silent, or hums without moving water.
Typical professional repair cost: Running Drain and Spin is free. A drain pump replacement typically costs $150–$250 with labor.
Frequently asked questions
How do I clear F0E8 on a Whirlpool washer?
Run a Drain and Spin cycle to remove the water. That is the step Whirlpool gives for this code.
Why is there water left in my washer?
F0E8 only says residual water was detected. A cycle that was interrupted, or a drain that is restricted, are the usual reasons.
When should I call for service with F0E8?
Whirlpool says to call if the problem persists after running Drain and Spin.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Washer F9 E1 The washer took too long to drain — check the drain hose setup and the pump filter; the 'hose pushed too far down the standpipe' mistake causes a surprising share of these.
- Whirlpool Washer F5 E2 The washer tried to lock its door and couldn't — usually an obstruction or grime in the latch, sometimes a worn lock assembly that needs replacing.
- Whirlpool Washer SD Too much foam — the washer paused its cycle to break down excess suds, which almost always traces back to detergent amount or type rather than a fault.
- Whirlpool Washer F8 E1 Your Whirlpool washer isn't detecting water coming in — usually a supply problem (taps, hoses, screens) rather than anything wrong inside the machine.
More: all Whirlpool washer codes · all Whirlpool codes · search by symptom