Whirlpool Washer F7 E2 — What It Means & How to Fix It
Also shown as F7E2 on some models.
On a Whirlpool top-load washer, F7E2 indicates an issue with the appliance control unit, user interface or associated wiring; try a 5-minute power reset and contact service if it does not clear.
What this code means
Whirlpool says the F7E2 alert indicates there is an issue with the appliance control unit, user interface or associated wiring. No mechanical checks are listed for owners — only the control reset. If that fails, the washer needs a technician with the model's tech sheet.
This description comes from Whirlpool's top-load washer help. Whirlpool's front-load F7 E2 article gives no meaning, so do not assume the same cause on a front loader.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Control glitch cleared by a reset | Common | Yes — power reset |
| Appliance control unit fault | Occasional | No — technician job |
| User interface or harness fault | Occasional | No — technician job |
What you can try yourself
- Unplug the washer for 5 minutes.
- Plug it in again.
- Reselect the cycle and press Start.
- If the code is displayed again, contact Whirlpool or schedule service.
When to call a technician
- F7E2 returns after resetting.
- The basket does not agitate or spin although the panel works.
- A burning smell or visible damage at the console — keep it unplugged.
Typical professional repair cost: Control unit replacement on a top-load washer commonly totals $200–$400 with labor.
Frequently asked questions
What does F7E2 mean on a Whirlpool top loader?
Whirlpool states it indicates an issue with the appliance control unit, user interface or associated wiring.
Is F7E2 a motor problem?
Whirlpool's top-load article does not name the motor; it names the control unit, user interface and wiring. A technician can confirm which is at fault.
What reset does Whirlpool recommend?
Disconnecting the washer from power for 5 minutes, then plugging it back in.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Washer F9 E1 The washer took too long to drain — check the drain hose setup and the pump filter; the 'hose pushed too far down the standpipe' mistake causes a surprising share of these.
- Whirlpool Washer F5 E2 The washer tried to lock its door and couldn't — usually an obstruction or grime in the latch, sometimes a worn lock assembly that needs replacing.
- Whirlpool Washer SD Too much foam — the washer paused its cycle to break down excess suds, which almost always traces back to detergent amount or type rather than a fault.
- Whirlpool Washer F8 E1 Your Whirlpool washer isn't detecting water coming in — usually a supply problem (taps, hoses, screens) rather than anything wrong inside the machine.
More: all Whirlpool washer codes · all Whirlpool codes · search by symptom