Whirlpool Washer F7 E7 — What It Means & How to Fix It
Also shown as F7E7 on some models.
F7E7 on a Whirlpool top-load washer signals an issue with the appliance control unit, user interface, or associated wiring — reset power for 5 minutes and call service if the code persists.
What this code means
Whirlpool's top-load help says the F7E7 alert indicates there is an issue with the appliance control unit, user interface, or associated wiring. As with its sibling codes, the only do-it-yourself step is to restart the control by removing power.
Sourced from Whirlpool's top-load washer help. The front-load F7 E7 article lists no meaning.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| One-off electronic fault | Common | Yes — power reset |
| Wiring fault between control unit and other components | Occasional | No — technician job |
| Control unit or user interface failure | Occasional | No — technician job |
What you can try yourself
- Stop the cycle and disconnect power for 5 minutes.
- Reconnect power.
- Run a short cycle with a small load.
- Schedule service if F7E7 shows again.
When to call a technician
- The code will not clear with a reset.
- It appears at the same point in every cycle.
- The washer stops with water in the tub and will not continue.
Typical professional repair cost: Repairs usually fall between $150 and $400 depending on whether wiring or a board is at fault.
Frequently asked questions
How do I fix F7E7 on a Whirlpool washer?
Start with the reset Whirlpool gives: unplug for 5 minutes, then plug back in. A code that persists needs service.
What part causes F7E7?
Whirlpool names three possibilities — the appliance control unit, the user interface, or the associated wiring — and does not narrow it further for owners.
My washer is full of water with F7E7 — what now?
After the power reset, try a Drain & Spin cycle. If it will not run, leave the water and call for service rather than tipping the washer.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Washer F9 E1 The washer took too long to drain — check the drain hose setup and the pump filter; the 'hose pushed too far down the standpipe' mistake causes a surprising share of these.
- Whirlpool Washer F5 E2 The washer tried to lock its door and couldn't — usually an obstruction or grime in the latch, sometimes a worn lock assembly that needs replacing.
- Whirlpool Washer SD Too much foam — the washer paused its cycle to break down excess suds, which almost always traces back to detergent amount or type rather than a fault.
- Whirlpool Washer F8 E1 Your Whirlpool washer isn't detecting water coming in — usually a supply problem (taps, hoses, screens) rather than anything wrong inside the machine.
More: all Whirlpool washer codes · all Whirlpool codes · search by symptom