Whirlpool Washer Int — What It Means & How to Fix It
Int means the cycle was paused or cancelled — the washer can take 20 to 30 minutes to stop and drain, after which pressing Pause or Cancel twice and Power once removes the code.
What this code means
Whirlpool says Int indicates the cycle was paused or cancelled. The washer can take 20 to 30 minutes to stop spinning and drain, and it shows Int during that time. It is a status message for an interrupted cycle rather than a fault.
A Whirlpool front-load message. Whirlpool notes that the method for removing the code varies by model.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Cycle paused or cancelled by the user | Very common | Yes — no tools |
| Washer still draining and slowing after a cancel | Common | Yes — wait |
| Control stuck after the interruption | Occasional | Yes — power reset |
What you can try yourself
- Give the washer time — up to 30 minutes — to stop spinning and drain.
- Press Pause or Cancel twice.
- Press Power once.
- If Int is still displayed, unplug the washer for 5 minutes and plug it back in.
Seeing the symptom rather than the code? Washer won't drain: checks that apply across brands.
When to call a technician
- Int remains after a 5-minute power disconnect.
- The door stays locked with water still in the drum.
- Int appears although nobody paused or cancelled anything.
Typical professional repair cost: No cost — this is normally cleared from the control panel.
Frequently asked questions
What does Int mean on a Whirlpool washer?
That the cycle was paused or cancelled.
Why is Int taking so long to clear?
The washer can take 20 to 30 minutes to stop spinning and drain, and Int is displayed for that whole time.
How do I remove the Int code?
Press Pause or Cancel twice, then Power once. If it stays, disconnect power for 5 minutes.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Washer F9 E1 The washer took too long to drain — check the drain hose setup and the pump filter; the 'hose pushed too far down the standpipe' mistake causes a surprising share of these.
- Whirlpool Washer F5 E2 The washer tried to lock its door and couldn't — usually an obstruction or grime in the latch, sometimes a worn lock assembly that needs replacing.
- Whirlpool Washer SD Too much foam — the washer paused its cycle to break down excess suds, which almost always traces back to detergent amount or type rather than a fault.
- Whirlpool Washer F8 E1 Your Whirlpool washer isn't detecting water coming in — usually a supply problem (taps, hoses, screens) rather than anything wrong inside the machine.
More: all Whirlpool washer codes · all Whirlpool codes · search by symptom