Amana Washer PF — What It Means & How to Fix It
Your Amana washer lost power mid-cycle — PF is the machine telling you the wash was interrupted, not that something broke.
What this code means
PF stands for power failure. When power drops out mid-cycle, the control board records it and shows PF so you know the cycle didn't finish normally. Amana's guidance is simple: touch and hold START to resume the cycle, or press POWER to clear the display. Because the load may have sat wet in the washer, run the cycle again without adding detergent.
PF is listed in Amana's own error-code table for top-load HE washers, and Amana shares the Whirlpool-family platform where PF means the same power-failure notice. It's an alert, not a parts fault.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Household power outage or tripped breaker | Very common | Yes — reset breaker, no tools |
| Washer on a switch-controlled outlet | Common | Yes — use a dedicated outlet |
| Loose or damaged power cord connection | Occasional | Yes — inspect the plug |
| Cord unplugged mid-cycle | Occasional | Yes — no tools |
What you can try yourself
- Touch and hold START, or press POWER, to clear the PF display — Amana says either action removes the code.
- Check the laundry circuit breaker or fuse and reset it if it tripped during the cycle.
- Confirm the washer is plugged into a dedicated outlet, not one controlled by a wall switch.
- Restart a full cycle without adding detergent, since the load sat wet in the drum.
- If PF returns on every cycle, have the outlet and power cord inspected for a loose connection.
When to call a technician
- The breaker trips repeatedly or you see scorch marks on the outlet — stop and call an electrician.
- Water remains in the drum and the washer won't restart or drain at all.
Typical professional repair cost: $0 for a reset; a service visit runs about $100–$200 if you schedule one
Frequently asked questions
Do I need to replace anything after PF?
Usually not — PF is a notice that power dropped, not a broken part. Clear it and rerun the cycle. If it keeps coming back, check the breaker and outlet before calling for service.
Will my clothes be clean if I just restart?
Restart the same cycle so the load gets a complete wash and rinse. The clothes sat in water, so finish the full cycle without adding detergent.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Amana codes
- Amana Washer Sud Too many suds — the Sud message means the washer added extra rinse to break down foam before it can spin.
- Amana Washer Ofb An out-of-balance load — Ofb appears when your washer is rebalancing an uneven load before it can spin.
- Amana Washer LdL Lid won't lock — LdL appears when the washer can't latch the lid, often because something is blocking it or the latch is gummed up.
- Amana Washer LdU The lid won't unlock — LdU tells you the washer can't release the lid, often because something is sitting on top of it.
More: all Amana washer codes · all Amana codes · search by symptom