Hisense Washer F02 — What It Means & How to Fix It
Also shown as F2 on some models.
Your Hisense washer sensed too much water — F02 is the overflow fault, so turn off the tap; the usual causes are a stuck inlet valve or a pressure-sensor problem.
What this code means
F02 on a Hisense washer means the water level went higher than it should, or the machine read an overflow. This can be an inlet valve that won't shut off or a fault in the pressure sensor that measures the level. Because it can mean water keeps coming in, the safe first move is to turn off the supply.
Unlike a simple fill or drain code, F02 is a water-level/overflow protection. Drying out and a reset can clear a one-off, but a valve stuck open or a sensor fault needs a technician — both sit inside the cabinet.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Inlet valve stuck open (keeps filling) | Common | No — technician job |
| Pressure sensor or its hose faulty | Common | No — technician job |
| One-time control misread | Occasional | Yes — power reset |
| Drainage too slow, raising the level | Occasional | Partly — check drain |
What you can try yourself
- If water is actively overfilling, turn off the supply tap straight away.
- Switch the washer off at the wall for a few minutes to clear a one-off misread, then retry.
- Check the drain hose and filter aren't blocked, since a slow drain can raise the level.
- If F02 returns or the machine keeps filling, leave the tap off and call a technician — a stuck valve or sensor fault is inside the cabinet.
When to call a technician
- The drum keeps filling or overfills.
- F02 returns after a reset.
- Water levels look wrong for the cycle (too high).
Typical professional repair cost: Inlet valve or pressure-sensor repair on a Hisense washer typically runs $120—$250 including labor.
Frequently asked questions
What does F02 mean on a Hisense washer?
Too much water, or an overflow. It usually means the inlet valve isn't shutting off or the pressure sensor is misreading the level. Turn off the tap and, if it returns, have it serviced.
Is F02 an emergency?
Turn off the supply tap to be safe, since the fault can mean water keeps entering. Once the water is off there's no rush — reset once, and book a technician if it returns.
Can I fix F02 myself?
Only a reset and checking the drain isn't slow. The inlet valve and pressure sensor are inside the cabinet, so a persistent F02 is a technician repair.
Related Hisense codes
- Hisense Washer F01 Your Hisense washer isn't filling — F01 is the water-inlet fault, usually a closed tap, a kinked hose, or a clogged inlet filter rather than the valve.
- Hisense Washer F03 Your Hisense washer can't drain — F03 is the drainage fault, usually a clogged pump filter, a kinked drain hose, or a blocked standpipe.
- Hisense Washer dE Your Hisense washer can't confirm the door is locked — dE is the door-lock fault, so the cycle won't start until it's satisfied the door is shut.
- Hisense Washer FA Your Hisense washer detected a leak — FA is the anti-flood trip, so turn off the supply; finding and fixing the leak is a technician job.
More: all Hisense washer codes · all Hisense codes · search by symptom