Hisense Washer FA — What It Means & How to Fix It
Your Hisense washer detected a leak — FA is the anti-flood trip, so turn off the supply; finding and fixing the leak is a technician job.
What this code means
FA on a Hisense washer means the leak-protection system found water in the base of the machine and stopped to prevent a flood. It usually keeps the pump running to clear the water. Because it means there's a leak inside the cabinet, the safe response is to turn off the water and have it diagnosed — not to open the machine.
Common sources are a failed hose, pump seal, or tub seal inside the cabinet — none of which are owner-serviceable. The one thing you can do is turn off the supply and dry around the machine; the rest is for a technician.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Water collecting in the base (leak protection tripped) | Very common | No — technician job |
| Failed internal hose or clamp | Common | No — technician job |
| Pump or tub seal leak | Occasional | No — technician job |
| One-time trip from a spill or heavy suds | Occasional | Yes — dry and reset |
What you can try yourself
- Turn off the water supply to the washer.
- Switch it off at the wall and mop up any water around or under the machine.
- If you suspect it was a one-off (a big spill or very heavy suds), let it dry, restore power, and test once with a short cycle.
- If FA returns, leave the water off and call a technician — a leak inside the cabinet isn't a safe DIY repair.
When to call a technician
- FA returns after drying out.
- You can see water under or around the washer.
- The machine keeps pumping or won't start a cycle.
Typical professional repair cost: Internal leak repair (hose, clamp, or seal) on a Hisense washer typically runs $150—$350 including labor.
Frequently asked questions
What does FA mean on a Hisense washer?
It's the leak/anti-flood trip — the machine found water in its base and stopped to prevent a flood. Turn off the supply; finding the leak inside the cabinet is a technician job.
Is it safe to keep using a washer with FA?
No — turn off the water and stop using it until the leak is found. The code exists to prevent a flood, so running it again risks water damage.
Could FA be a false alarm?
Occasionally a big spill or very heavy suds trips it once. If drying out and a single retry clears it, that may have been it — but if FA returns, treat it as a real leak and call for service.
Related Hisense codes
- Hisense Washer F01 Your Hisense washer isn't filling — F01 is the water-inlet fault, usually a closed tap, a kinked hose, or a clogged inlet filter rather than the valve.
- Hisense Washer F02 Your Hisense washer sensed too much water — F02 is the overflow fault, so turn off the tap; the usual causes are a stuck inlet valve or a pressure-sensor problem.
- Hisense Washer F03 Your Hisense washer can't drain — F03 is the drainage fault, usually a clogged pump filter, a kinked drain hose, or a blocked standpipe.
- Hisense Washer dE Your Hisense washer can't confirm the door is locked — dE is the door-lock fault, so the cycle won't start until it's satisfied the door is shut.
More: all Hisense washer codes · all Hisense codes · search by symptom