Whirlpool Laundry Tower F0E3 — What It Means & How to Fix It
Also shown as F0 E3 on some models.
F0E3 on a Laundry Tower is overload detection — take some items out, reset power, and schedule service if it comes back.
What this code means
Whirlpool gives the potential cause as over load detection, with cycling power as the troubleshooting step.
Whirlpool lists this code for both the washer and the dryer of the Laundry Tower with the same potential cause.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Drum overloaded | Very common | Yes — reduce load |
| Sensing fault | Occasional | No — technician job |
What you can try yourself
- Remove part of the load.
- Disconnect power for 5 minutes.
- Restart with a smaller load.
- Service on a repeat.
When to call a technician
- Code on small loads.
- Repeat after reset.
- Drum hard to turn.
Typical professional repair cost: Free normally.
Frequently asked questions
What does F0E3 mean on a Laundry Tower?
Over load detection.
Reset?
Disconnect power, then restart.
Washer or dryer?
Whirlpool lists it for both.
Sources checked
- Whirlpool Product Help: F0E3 Error Code - Laundry Tower (washer)
- Whirlpool Product Help: F0E3 Error Code - Laundry Tower (dryer)
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Laundry Tower F0E2 F0E2 on a Whirlpool Laundry Tower is over-suds detection — use only HE detergent, measure the dose, and clean the washer regularly.
- Whirlpool Laundry Tower F0E4 F0E4 on a Laundry Tower means the water temperature is too hot — check the hot and cold hoses are not switched, then reset power.
- Whirlpool Laundry Tower F0E5 F0E5 on a Laundry Tower is an off-balance load — if the clothes are dripping, reduce or rebalance the load and run a spin; if not, the cycle just took longer to balance.
- Whirlpool Laundry Tower F0E6 F0E6 on a Laundry Tower points to the measurement sensor; reset power and schedule service if it returns.
More: all Whirlpool laundry tower codes · all Whirlpool codes · search by symptom