Whirlpool Laundry Tower F0E6 — What It Means & How to Fix It
Also shown as F0 E6 on some models.
F0E6 on a Laundry Tower points to the measurement sensor; reset power and schedule service if it returns.
What this code means
Whirlpool gives the potential cause as "Measurement Sensor" and the troubleshooting as cycling power.
Whirlpool lists this code for both the washer and the dryer of the Laundry Tower with the same potential cause. Whirlpool does not say what the sensor measures.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Measurement sensor fault | Common | No — technician job |
| Glitch | Occasional | Yes — power reset |
What you can try yourself
- Disconnect power for 5 minutes.
- Reconnect.
- Run a cycle.
- Schedule service on a repeat.
When to call a technician
- Repeat code.
- Cycles stall.
- Other F0 codes.
Typical professional repair cost: About $120–$300.
Frequently asked questions
What does F0E6 mean?
Whirlpool lists the potential cause as the measurement sensor.
What can I do?
Cycle power.
Then?
Schedule service if it returns.
Sources checked
- Whirlpool Product Help: F0E6 Error Code - Laundry Tower (washer)
- Whirlpool Product Help: F0E6 Error Code - Laundry Tower (dryer)
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Laundry Tower F0E2 F0E2 on a Whirlpool Laundry Tower is over-suds detection — use only HE detergent, measure the dose, and clean the washer regularly.
- Whirlpool Laundry Tower F0E3 F0E3 on a Laundry Tower is overload detection — take some items out, reset power, and schedule service if it comes back.
- Whirlpool Laundry Tower F0E4 F0E4 on a Laundry Tower means the water temperature is too hot — check the hot and cold hoses are not switched, then reset power.
- Whirlpool Laundry Tower F0E5 F0E5 on a Laundry Tower is an off-balance load — if the clothes are dripping, reduce or rebalance the load and run a spin; if not, the cycle just took longer to balance.
More: all Whirlpool laundry tower codes · all Whirlpool codes · search by symptom