Whirlpool Laundry Tower F0E4 — What It Means & How to Fix It

Also shown as F0 E4 on some models.

By Callum Griffin · Researched and verified against manufacturer and repair documentation · Reviewed September 2026

F0E4 on a Laundry Tower means the water temperature is too hot — check the hot and cold hoses are not switched, then reset power.

What this code means

Whirlpool gives the potential cause as water temperature too hot and tells you to check the water hose connection: verify the hoses are installed correctly and not switched between hot and cold.

Listed in Whirlpool's Laundry Tower washer code table.

Most likely causes

What you can try yourself

1. Turn off the water.
2. Check hot goes to hot and cold to cold.
3. Swap if crossed and tighten.
4. Reset power for 5 minutes.

When to call a technician

Frequently asked questions

Sources checked

• Whirlpool Product Help: F0E4 Error Code - Laundry Tower (washer)

Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.

Related Whirlpool codes

• Whirlpool Laundry Tower F0E2 F0E2 on a Whirlpool Laundry Tower is over-suds detection — use only HE detergent, measure the dose, and clean the washer regularly.
• Whirlpool Laundry Tower F0E3 F0E3 on a Laundry Tower is overload detection — take some items out, reset power, and schedule service if it comes back.
• Whirlpool Laundry Tower F0E5 F0E5 on a Laundry Tower is an off-balance load — if the clothes are dripping, reduce or rebalance the load and run a spin; if not, the cycle just took longer to balance.
• Whirlpool Laundry Tower F0E6 F0E6 on a Laundry Tower points to the measurement sensor; reset power and schedule service if it returns.

More: all Whirlpool laundry tower codes · all Whirlpool codes · search by symptom