Whirlpool Laundry Tower F0E7 — What It Means & How to Fix It
Also shown as F0 E7 on some models.
F0E7 on a Laundry Tower means clothes were detected during the Clean Washer cycle — empty the washer and restart it.
What this code means
Whirlpool gives the potential cause as clothes detected during Clean Washer cycle: remove the load and restart; call for service if the problem persists.
Listed in Whirlpool's Laundry Tower washer code table.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Laundry left in the drum | Very common | Yes — no tools |
| Sensing fault | Less common | No — technician job |
What you can try yourself
- Empty the drum.
- Restart Clean Washer.
- If it shows when empty, reset power.
- Call for service if it persists.
When to call a technician
- Code when empty.
- Repeat after reset.
- Drum stiff.
Typical professional repair cost: Free.
Frequently asked questions
What does F0E7 mean?
Clothes detected during the Clean Washer cycle.
Fix?
Remove the load and restart.
Still there?
Call for service.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Laundry Tower F0E2 F0E2 on a Whirlpool Laundry Tower is over-suds detection — use only HE detergent, measure the dose, and clean the washer regularly.
- Whirlpool Laundry Tower F0E3 F0E3 on a Laundry Tower is overload detection — take some items out, reset power, and schedule service if it comes back.
- Whirlpool Laundry Tower F0E4 F0E4 on a Laundry Tower means the water temperature is too hot — check the hot and cold hoses are not switched, then reset power.
- Whirlpool Laundry Tower F0E5 F0E5 on a Laundry Tower is an off-balance load — if the clothes are dripping, reduce or rebalance the load and run a spin; if not, the cycle just took longer to balance.
More: all Whirlpool laundry tower codes · all Whirlpool codes · search by symptom