Whirlpool Laundry Tower F2E2 — What It Means & How to Fix It
Also shown as F2 E2, F2E3, F2 E3 on some models.
F2E2 and F2E3 on a Laundry Tower are communication errors; reset power and schedule service if either returns.
What this code means
Whirlpool gives the potential cause of both codes as "Communication Error".
Whirlpool lists this code for both the washer and the dryer of the Laundry Tower with the same potential cause.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Communication glitch | Common | Yes — power reset |
| Harness or interface fault | Occasional | No — technician job |
What you can try yourself
- Disconnect power for 5 minutes.
- Reconnect.
- Test.
- Service on a repeat.
When to call a technician
- Repeat code.
- Frozen display.
- No response.
Typical professional repair cost: About $200–$400.
Frequently asked questions
What do F2E2 and F2E3 mean?
Communication error.
Between what?
Whirlpool does not specify.
Reset?
Cycle power.
Sources checked
- Whirlpool Product Help: F2E2 Error Code - Laundry Tower (washer)
- Whirlpool Product Help: F2E3 Error Code - Laundry Tower (washer)
- Whirlpool Product Help: F2E2 Error Code - Laundry Tower (dryer)
- Whirlpool Product Help: F2E3 Error Code - Laundry Tower (dryer)
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Laundry Tower F0E2 F0E2 on a Whirlpool Laundry Tower is over-suds detection — use only HE detergent, measure the dose, and clean the washer regularly.
- Whirlpool Laundry Tower F0E3 F0E3 on a Laundry Tower is overload detection — take some items out, reset power, and schedule service if it comes back.
- Whirlpool Laundry Tower F0E4 F0E4 on a Laundry Tower means the water temperature is too hot — check the hot and cold hoses are not switched, then reset power.
- Whirlpool Laundry Tower F0E5 F0E5 on a Laundry Tower is an off-balance load — if the clothes are dripping, reduce or rebalance the load and run a spin; if not, the cycle just took longer to balance.
More: all Whirlpool laundry tower codes · all Whirlpool codes · search by symptom