Whirlpool Laundry Tower F6E1 — What It Means & How to Fix It
Also shown as F6 E1, F6E2, F6E3, F6E4, F6E5, F1E3 on some models.
F6E1 through F6E5, and F1E3, on a Laundry Tower are control communication faults; reset power and schedule service if the code returns.
What this code means
Whirlpool gives the potential cause of each of these codes as "Control Communication" — the tower's control units are not talking to each other correctly.
Whirlpool lists this code for both the washer and the dryer of the Laundry Tower with the same potential cause. Six separate codes with one stated cause.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Communication glitch after a power event | Common | Yes — power reset |
| Harness fault between washer and dryer controls | Occasional | No — technician job |
| Control fault | Occasional | No — technician job |
What you can try yourself
- Disconnect power for 5 minutes.
- Reconnect.
- Test both washer and dryer.
- Schedule service on a repeat.
When to call a technician
- Repeat code.
- One half of the tower unresponsive.
- Display frozen.
Typical professional repair cost: About $200–$500.
Frequently asked questions
What do F6 codes mean on a Laundry Tower?
Control communication.
Why is F1E3 here?
Whirlpool gives it the same potential cause.
Reset?
Cycle power.
Sources checked
- Whirlpool Product Help: F6E1 Error Code - Laundry Tower (washer)
- Whirlpool Product Help: F6E2 Error Code - Laundry Tower (washer)
- Whirlpool Product Help: F6E3 Error Code - Laundry Tower (washer)
- Whirlpool Product Help: F6E4 Error Code - Laundry Tower (washer)
- Whirlpool Product Help: F6E5 Error Code - Laundry Tower (washer)
- Whirlpool Product Help: F1E3 Error Code - Laundry Tower (washer)
- Whirlpool Product Help: F6E1 Error Code - Laundry Tower (dryer)
- Whirlpool Product Help: F1E3 Error Code - Laundry Tower (dryer)
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Laundry Tower F0E2 F0E2 on a Whirlpool Laundry Tower is over-suds detection — use only HE detergent, measure the dose, and clean the washer regularly.
- Whirlpool Laundry Tower F0E3 F0E3 on a Laundry Tower is overload detection — take some items out, reset power, and schedule service if it comes back.
- Whirlpool Laundry Tower F0E4 F0E4 on a Laundry Tower means the water temperature is too hot — check the hot and cold hoses are not switched, then reset power.
- Whirlpool Laundry Tower F0E5 F0E5 on a Laundry Tower is an off-balance load — if the clothes are dripping, reduce or rebalance the load and run a spin; if not, the cycle just took longer to balance.
More: all Whirlpool laundry tower codes · all Whirlpool codes · search by symptom