Whirlpool Laundry Tower F7E3 — What It Means & How to Fix It
Also shown as F7 E3, F7E4 on some models.
F7E3 and F7E4 on a Laundry Tower point to the wash basket; check nothing is jamming the drum, reset power, and schedule service if the code returns.
What this code means
Whirlpool gives the potential cause of both codes as "Wash Basket".
Listed in Whirlpool's Laundry Tower washer code table. Whirlpool gives only the two-word cause.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Item jamming the basket | Common | Partly — check drum |
| Overloaded basket | Common | Yes — reduce load |
| Drive fault | Occasional | No — technician job |
What you can try yourself
- Empty the washer.
- Turn the drum by hand and feel for obstruction.
- Reset power.
- Service on a repeat.
When to call a technician
- Drum will not turn by hand.
- Scraping noise.
- Repeat code.
Typical professional repair cost: About $150–$400.
Frequently asked questions
What do F7E3 and F7E4 mean?
Wash basket.
What should I check?
That the drum turns freely and is not overloaded.
Reset?
Cycle power.
Sources checked
- Whirlpool Product Help: F7E3 Error Code - Laundry Tower (washer)
- Whirlpool Product Help: F7E4 Error Code - Laundry Tower (washer)
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Laundry Tower F0E2 F0E2 on a Whirlpool Laundry Tower is over-suds detection — use only HE detergent, measure the dose, and clean the washer regularly.
- Whirlpool Laundry Tower F0E3 F0E3 on a Laundry Tower is overload detection — take some items out, reset power, and schedule service if it comes back.
- Whirlpool Laundry Tower F0E4 F0E4 on a Laundry Tower means the water temperature is too hot — check the hot and cold hoses are not switched, then reset power.
- Whirlpool Laundry Tower F0E5 F0E5 on a Laundry Tower is an off-balance load — if the clothes are dripping, reduce or rebalance the load and run a spin; if not, the cycle just took longer to balance.
More: all Whirlpool laundry tower codes · all Whirlpool codes · search by symptom