Whirlpool Laundry Tower F8E4 — What It Means & How to Fix It
Also shown as F8 E4 on some models.
F8E4 on a Laundry Tower points to the flow meter; check the water supply, reset power, and schedule service if it returns.
What this code means
Whirlpool gives the potential cause as "Flow Meter" — the part that measures incoming water.
Listed in Whirlpool's Laundry Tower washer code table.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Flow meter fault | Common | No — technician job |
| Low water flow | Occasional | Yes — check supply |
What you can try yourself
- Check faucets are open.
- Reset power.
- Test a fill.
- Service on a repeat.
When to call a technician
- Repeat code.
- Wrong fill levels.
- Other F8 codes.
Typical professional repair cost: About $120–$250.
Frequently asked questions
What does F8E4 mean?
Flow meter.
What does it do?
It measures water entering the washer.
Reset?
Cycle power.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Laundry Tower F0E2 F0E2 on a Whirlpool Laundry Tower is over-suds detection — use only HE detergent, measure the dose, and clean the washer regularly.
- Whirlpool Laundry Tower F0E3 F0E3 on a Laundry Tower is overload detection — take some items out, reset power, and schedule service if it comes back.
- Whirlpool Laundry Tower F0E4 F0E4 on a Laundry Tower means the water temperature is too hot — check the hot and cold hoses are not switched, then reset power.
- Whirlpool Laundry Tower F0E5 F0E5 on a Laundry Tower is an off-balance load — if the clothes are dripping, reduce or rebalance the load and run a spin; if not, the cycle just took longer to balance.
More: all Whirlpool laundry tower codes · all Whirlpool codes · search by symptom