Whirlpool Laundry Tower F8E5 — What It Means & How to Fix It
Also shown as F8 E5 on some models.
F8E5 on a Laundry Tower means the water supply is reversed — attach the hot line to the hot inlet and the cold to the cold, then reset power.
What this code means
Whirlpool gives the potential cause as water supply reversed: ensure the hot water line is attached to the hot water inlet, and the same for cold.
Listed in Whirlpool's Laundry Tower washer code table.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Hoses crossed at installation | Very common | Yes — swap |
What you can try yourself
- Turn off the water.
- Swap the hoses at the washer.
- Turn the water on and check for leaks.
- Reset power.
When to call a technician
- Correct hoses, code returns.
- Leaks.
- Faucets plumbed backwards.
Typical professional repair cost: Free.
Frequently asked questions
What does F8E5 mean?
Water supply reversed.
Fix?
Hot to hot, cold to cold.
Then?
Cycle power.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Laundry Tower F0E2 F0E2 on a Whirlpool Laundry Tower is over-suds detection — use only HE detergent, measure the dose, and clean the washer regularly.
- Whirlpool Laundry Tower F0E3 F0E3 on a Laundry Tower is overload detection — take some items out, reset power, and schedule service if it comes back.
- Whirlpool Laundry Tower F0E4 F0E4 on a Laundry Tower means the water temperature is too hot — check the hot and cold hoses are not switched, then reset power.
- Whirlpool Laundry Tower F0E5 F0E5 on a Laundry Tower is an off-balance load — if the clothes are dripping, reduce or rebalance the load and run a spin; if not, the cycle just took longer to balance.
More: all Whirlpool laundry tower codes · all Whirlpool codes · search by symptom