Whirlpool Laundry Tower F8E6 — What It Means & How to Fix It
Also shown as F8 E6 on some models.
F8E6 on a Laundry Tower means water was detected — look for a leak, close the faucets if you find water, and schedule service if the code returns.
What this code means
Whirlpool gives the potential cause as "Water Detected" and says to schedule service if the code returns. It gives no further detail.
Listed in Whirlpool's Laundry Tower washer code table. Whirlpool does not say where the water is detected.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Leak inside or under the washer | Common | Partly — inspect |
| Oversudsing overflow | Occasional | Yes — detergent |
| Sensor fault | Occasional | No — technician job |
What you can try yourself
- Check the floor and under the tower for water.
- Close the faucets if you find any.
- Dry up and reset power.
- Schedule service on a repeat.
When to call a technician
- Visible leak.
- Repeat code.
- Water with the machine off.
Typical professional repair cost: About $120–$300.
Frequently asked questions
What does F8E6 mean on a Laundry Tower?
Water detected.
Is it a leak?
Whirlpool does not elaborate; check for water to be safe.
Next?
Schedule service if it returns.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Laundry Tower F0E2 F0E2 on a Whirlpool Laundry Tower is over-suds detection — use only HE detergent, measure the dose, and clean the washer regularly.
- Whirlpool Laundry Tower F0E3 F0E3 on a Laundry Tower is overload detection — take some items out, reset power, and schedule service if it comes back.
- Whirlpool Laundry Tower F0E4 F0E4 on a Laundry Tower means the water temperature is too hot — check the hot and cold hoses are not switched, then reset power.
- Whirlpool Laundry Tower F0E5 F0E5 on a Laundry Tower is an off-balance load — if the clothes are dripping, reduce or rebalance the load and run a spin; if not, the cycle just took longer to balance.
More: all Whirlpool laundry tower codes · all Whirlpool codes · search by symptom