Whirlpool Washer Dryer Combo F1E4 — What It Means & How to Fix It
Also shown as F1 E4 on some models.
F1E4 indicates a possible problem with the main relay; unplug the machine for at least 5 minutes, and call for service if that does not clear it.
What this code means
Whirlpool calls F1E4 a Main Relay Error: there may be a problem with the main relay.
Whirlpool all-in-one (ventless) washer dryers.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Main relay fault on the control | Common | No — technician job |
| Glitch | Occasional | Yes — unplug 5 minutes |
What you can try yourself
- Unplug for at least 5 minutes.
- Plug back in.
- Start a cycle.
- Call for service if it returns.
When to call a technician
- Repeat code.
- Machine dead.
- Clicking from the control.
Typical professional repair cost: About $200–$400.
Frequently asked questions
What does F1E4 mean?
A possible main relay problem.
Reset?
Unplug 5 minutes.
DIY?
No.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Washer Dryer Combo F0E1 F0E1 means you started a Clean Washer cycle and the machine detects items still inside — remove the load and restart the cycle.
- Whirlpool Washer Dryer Combo F0E2 F0E2 means excessive suds were detected and the machine is running a suds reduction routine — let it finish, then switch to measured HE detergent and run a Clean Washer cycle.
- Whirlpool Washer Dryer Combo F0E3 F0E3 means temperatures inside the machine got too hot during the dry cycle — check you are using the right cycle for the fabric, then unplug for 5 minutes to reset.
- Whirlpool Washer Dryer Combo F0E4 F0E4 means the wash water is too hot, usually because the machine is connected to the hot supply — it must be connected to cold water only.
More: all Whirlpool washer dryer combo codes · all Whirlpool codes · search by symptom