Whirlpool Washer Dryer Combo F3E1 — What It Means & How to Fix It
Also shown as F3 E1 on some models.
F3E1 indicates a possible problem with the water pressure sensor — check the water supply pressure, unplug for 5 minutes, and run a drain-only cycle if water remains.
What this code means
Whirlpool says F3E1 indicates there may be a problem with the water pressure sensor, and asks you to verify the supply has adequate pressure. You may need a drain-only cycle if water is still in the machine.
Whirlpool all-in-one (ventless) washer dryers.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Low household water pressure | Common | Yes — check supply |
| Pressure sensor fault | Common | No — technician job |
| Glitch | Occasional | Yes — unplug 5 minutes |
What you can try yourself
- Check the faucet is fully open and pressure is normal.
- Unplug for at least 5 minutes.
- Run a drain-only cycle if water remains.
- Call for service if unsuccessful.
When to call a technician
- Repeat code.
- Water left in the drum.
- Overfilling.
Typical professional repair cost: About $120–$250.
Frequently asked questions
What does F3E1 mean on an all-in-one?
A possible water pressure sensor problem.
Water still inside?
Run a drain-only cycle.
Reset?
Unplug 5 minutes.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Washer Dryer Combo F0E1 F0E1 means you started a Clean Washer cycle and the machine detects items still inside — remove the load and restart the cycle.
- Whirlpool Washer Dryer Combo F0E2 F0E2 means excessive suds were detected and the machine is running a suds reduction routine — let it finish, then switch to measured HE detergent and run a Clean Washer cycle.
- Whirlpool Washer Dryer Combo F0E3 F0E3 means temperatures inside the machine got too hot during the dry cycle — check you are using the right cycle for the fabric, then unplug for 5 minutes to reset.
- Whirlpool Washer Dryer Combo F0E4 F0E4 means the wash water is too hot, usually because the machine is connected to the hot supply — it must be connected to cold water only.
More: all Whirlpool washer dryer combo codes · all Whirlpool codes · search by symptom