Whirlpool Washer Dryer Combo F3E2 — What It Means & How to Fix It
Also shown as F3 E2 on some models.
F3E2 indicates a possible issue with the temperature control sensor; unplug for 5 minutes and call service if it persists.
What this code means
Whirlpool says F3E2 indicates there may be an issue with the temperature control sensor.
Whirlpool all-in-one (ventless) washer dryers.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Temperature sensor fault | Common | No — technician job |
| Glitch | Occasional | Yes — unplug 5 minutes |
What you can try yourself
- Unplug 5 minutes.
- Plug in.
- Run a cycle.
- Service on a repeat.
When to call a technician
- Repeat code.
- Water too hot or cold.
- Dry cycle fails.
Typical professional repair cost: About $120–$250.
Frequently asked questions
What does F3E2 mean?
A possible temperature control sensor issue.
Reset?
Unplug 5 minutes.
DIY?
No.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Washer Dryer Combo F0E1 F0E1 means you started a Clean Washer cycle and the machine detects items still inside — remove the load and restart the cycle.
- Whirlpool Washer Dryer Combo F0E2 F0E2 means excessive suds were detected and the machine is running a suds reduction routine — let it finish, then switch to measured HE detergent and run a Clean Washer cycle.
- Whirlpool Washer Dryer Combo F0E3 F0E3 means temperatures inside the machine got too hot during the dry cycle — check you are using the right cycle for the fabric, then unplug for 5 minutes to reset.
- Whirlpool Washer Dryer Combo F0E4 F0E4 means the wash water is too hot, usually because the machine is connected to the hot supply — it must be connected to cold water only.
More: all Whirlpool washer dryer combo codes · all Whirlpool codes · search by symptom