Whirlpool Washer Dryer Combo F6E1 — What It Means & How to Fix It
Also shown as F6 E1, F6E2, F6 E2 on some models.
F6E1 and F6E2 indicate a possible communication failure between the machine's electronics; unplug for 5 minutes and call service if it returns.
What this code means
Whirlpool says these codes indicate there may be a communication failure between the electronics in the washer/dryer.
Whirlpool all-in-one (ventless) washer dryers.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Communication glitch | Common | Yes — unplug 5 minutes |
| Board or harness fault | Occasional | No — technician job |
What you can try yourself
- Unplug 5 minutes.
- Plug in.
- Start a cycle.
- Service on a repeat.
When to call a technician
- Repeat code.
- Frozen display.
- Stops mid-cycle.
Typical professional repair cost: About $200–$400.
Frequently asked questions
What do F6E1 and F6E2 mean?
A possible communication failure between the electronics.
Reset?
Unplug 5 minutes.
DIY?
No.
Sources checked
- Whirlpool Product Help: F6E1 - All-In-One Washer Dryer
- Whirlpool Product Help: F6E2 - All-In-One Washer Dryer
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Washer Dryer Combo F0E1 F0E1 means you started a Clean Washer cycle and the machine detects items still inside — remove the load and restart the cycle.
- Whirlpool Washer Dryer Combo F0E2 F0E2 means excessive suds were detected and the machine is running a suds reduction routine — let it finish, then switch to measured HE detergent and run a Clean Washer cycle.
- Whirlpool Washer Dryer Combo F0E3 F0E3 means temperatures inside the machine got too hot during the dry cycle — check you are using the right cycle for the fabric, then unplug for 5 minutes to reset.
- Whirlpool Washer Dryer Combo F0E4 F0E4 means the wash water is too hot, usually because the machine is connected to the hot supply — it must be connected to cold water only.
More: all Whirlpool washer dryer combo codes · all Whirlpool codes · search by symptom