Whirlpool Washer Dryer Combo F8E3 — What It Means & How to Fix It
Also shown as F8 E3 on some models.
F8E3 indicates a possible internal overflow from the water inlet valve; check the drain hose and drain pump filter are not plugged, and call service if that does not fix it.
What this code means
Whirlpool says F8E3 indicates there may be an internal overflow from the water inlet valve, and asks you to verify the drain hose and drain pump filter are not plugged.
Whirlpool all-in-one (ventless) washer dryers.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Plugged drain pump filter | Common | Yes — clean filter |
| Plugged drain hose | Common | Yes — clear hose |
| Inlet valve not closing | Occasional | No — technician job |
What you can try yourself
- Clean the drain pump filter per the manual.
- Check the drain hose.
- If water enters when off, close the supply valve.
- Call for service.
When to call a technician
- Water rising with the machine off.
- Repeat code.
- Water on the floor.
Typical professional repair cost: Free to $200.
Frequently asked questions
What does F8E3 mean on an all-in-one?
A possible internal overflow from the inlet valve.
What to check?
Drain hose and drain pump filter.
Water keeps coming in?
Close the supply valve and call service.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Washer Dryer Combo F0E1 F0E1 means you started a Clean Washer cycle and the machine detects items still inside — remove the load and restart the cycle.
- Whirlpool Washer Dryer Combo F0E2 F0E2 means excessive suds were detected and the machine is running a suds reduction routine — let it finish, then switch to measured HE detergent and run a Clean Washer cycle.
- Whirlpool Washer Dryer Combo F0E3 F0E3 means temperatures inside the machine got too hot during the dry cycle — check you are using the right cycle for the fabric, then unplug for 5 minutes to reset.
- Whirlpool Washer Dryer Combo F0E4 F0E4 means the wash water is too hot, usually because the machine is connected to the hot supply — it must be connected to cold water only.
More: all Whirlpool washer dryer combo codes · all Whirlpool codes · search by symptom