Whirlpool Oven Door — What It Means & How to Fix It
Also shown as DOOR on some models.
Door in the microwave display of a combination wall oven means the control is looking for input from the door switches — open and close the microwave door.
What this code means
Whirlpool says to open and close the door; the control is looking for input from the door switches.
Combination wall ovens with a microwave.
Most likely causes
| Cause | How likely | DIY-fixable? |
|---|---|---|
| Door not cycled since loading | Very common | Yes — no tools |
| Door not fully closed | Common | Yes — no tools |
| Door switch fault | Occasional | No — technician job |
What you can try yourself
- Open the microwave door.
- Close it firmly.
- Press Start.
- Reset the breaker if Door stays; service on a repeat.
When to call a technician
- Door message with the door firmly shut.
- Latch damaged.
- Microwave runs with the door open — breaker off.
Typical professional repair cost: Free normally; switch repair $100–$200.
Frequently asked questions
Why does the microwave display say Door?
The control is looking for input from the door switches.
Fix?
Open and close the door.
Still there?
Reset power, then call service.
Sources checked
Error meanings can vary by model. This guide was checked against the documentation above; use the manual for the model number on your own appliance when it differs.
Related Whirlpool codes
- Whirlpool Oven F0 E0 F0 E0 on a Whirlpool wall oven appears when the electronic oven control cannot recognise what type of problem has occurred; reset the breaker for one minute and call service if it returns.
- Whirlpool Oven F1 E0 F1 E0 on a wall oven indicates a possible problem with the user interface (touchpad), the control, or the wiring — clean the panel, reset the breaker, and call service if it persists.
- Whirlpool Oven F1 E1 F1 E1 points to the oven appliance manager control — one of the oven's control boards — or its wiring; reset power and call service if it returns.
- Whirlpool Oven F1 E2 F1 E2 points to the microwave user interface on a combination wall oven, or its wiring; reset power and call service if it repeats.
More: all Whirlpool oven codes · all Whirlpool codes · search by symptom